殷富永凝防水建材(中國)有限公司

Product Series Introduction

Concrete deep sealant(DPS)

Inosuke

DPS is a kind of antitoxic, environmentally protective concrete deep layer seal, suitable for all new and old concrete projects. After using DPS, the active catalytic agent in DPS is reacted with quaternary substances such as semi-hydrated cement, paraffin, and paraffin ash in concrete to produce an unmanufactured Silicon crystal(known as "King of Silicon" in the United States, and the crystal formation depth can reach more than 20mm), In the interior of the concrete, a dense protective layer is formed to make the concrete waterproof and the outer layer more solid at the same time. It has the effect of reducing water vapor, separating chlorides and preventing acid from invading. In addition, the DPS will fill all the small pores in the concrete interior and form a part of the concrete body, from which it reaches the enhancement function.



Function
1、Permanent waterproof and anti-moisture to eliminate air pollution caused by capillary effects
2、Soda and invasion of alkaloic acid and chemical substances
3、Reduction of 60 % moisture loss in concrete interior to prevent small cracks and dry spots
4、Anti-mildew, antimicrobial, anti-fouling
5、Inhibitory concrete shrinkage, increase concrete strength
6、Self-closing crack below 0.3 mm
7、Make new and old concrete close together
8、High temperature resistance, low temperature resistance, prevent freezing damage

9、To prevent the harm of carbonization, alkaline aggregate reaction


Characteristics
1、Suitable for new and old concrete buildings and structures
2、No shelf life and no shelf temperature limit.
3、Construction efficiency
4、The base surface is dry and smooth, and it can be constructed 24 hours a day.
5、Enables the concrete to be protected naturally, without anyprotective facilities, and saves project costs.

6、The Environmental protection is harmless, has no influence on the human body, environment, and can be constructed under no wind conditions.


Use the range
Concrete waterproofing, corrosion protection and durability protection for premises projects, water storage facilities, road bridges, tunnels and port terminals


Method of application
1、Do not explain or mix other liquids, use force to bubble(1-2 minutes) before use
2、Clean the construction surface with clean water, directly with a brush, roll or low pressure spray on the ground surface or wet construction.
3、When it should be used on the surface, the spray device should be applied from left to right from the bottom up until the completion of the entire construction surface, and the rules and regulations are used to make the spray twice. 24 hours between the first pass and the second pass; If you only want to increase the strength and hardness of the concrete, you only need to spray a layer of DPS, of course, depending on the pressure of the water.
4、If the concrete is over-divided or affected by other environments(such as near seawater and rivers), only four DPSs(possibly fewer times) can be used to solve the problem.
5、For the new concrete, DPS spray can be used when the strength reaches 1.2 Mpa; The vertical formed concrete surface can be sprayed after the outer mold is removed and cleaned. The use of DPS has greatly improved the state of the new concrete shelter. Its protection can solve the problem of excessive water loss of concrete and reduce 90 % of the amount.
6、Please should not be used on the glass materials, if accidental contact should be immediately washed with water.
7、Construction conditions: Concrete surface temperature between 2 °C -45 °C, 10 % -90 %.

8、If there are holes or cracks in the surface of the concrete, please ask us about the repair of the permanent condensation solution.


Pay attention.
1、Each time using the congealed liquid DPS, it must be used again if it is separated by an hour.
2、Such as the permanent condensation of DPS into the eye, with water cleaning or treatment.
3、If there are holes or cracks in the concrete surface need repair, please consult our experienced technical engineer.
4、Please should not be used on the glass to avoid damage to the surface. In case of accidental contact or glass material, rinse with water immediately.


Copyright © 2005-2009 殷富永凝防水建材(中國)有限公司 All Rights Reserved Guangdong ICP No. 14038025 Powered by:www.0208d.com